Fitted properly. Wired neatly.

A physical installation demonstration of MBLEM, a show and display product, based on a fitting on our demo car. The emblem is wired into the car’s 12 V electrics, so we recommend a qualified installer. Fitting isn’t included in the price.

  • 12 VWired into your car’s electrics
  • InstallerQualified fitting recommended
  • SeparateFitting isn’t included in the price
See the eight stepsCheck it fits
Illustration
Illustration of a boot lid seen from behindThe round MBLEM emblem sits where the original rear badge was. A lead runs from the back of the emblem inside the boot lid, through the conduit at the hinge, to a fused supply connected by an installer.
  1. The MBLEM emblem takes the place of the original rear badge.
  2. Its lead is routed inside the boot lid and through the hinge-side conduit.
  3. Your installer connects it to a suitable fused supply.

From a fitting on our demo car

What your installer will do

These eight steps are an overview, not instructions. Your installer’s method may differ for your car.

1 min 28 s · Sound optional

01The original badge comes off

  1. 01 0:00

    The original rear badge is removed. The surrounding paint is protected with tape.

  2. 02 0:05

    The boot and lid trim are opened to access the wiring route.

  3. 03 0:17

    On this car, the display lead passes through an existing hole in the badge recess.

  4. 04 0:25

    The backing is peeled away, then the display is seated in the recess.

  5. 05 0:32

    The lead is routed inside the boot lid.

  6. 06 0:42

    The lead is guided through the hinge-side rubber conduit.

  7. 07 1:01

    Electrical connections are completed. Wiring must be assessed by a qualified installer.

  8. 08 1:21

    The fitted display is shown working. For shows and private-land use.

On the bench

Tools we saw used

What we saw on our demo fitting. It isn’t a shopping list, and your installer will bring their own.

  • Masking tapeTo protect the paint around the badge
  • Plastic trim toolsTo ease the original badge off
  • A draw wireTo pull the lead through the hinge conduit
  • A fuse tapUsed on our demo car for the fused connection
  • PliersUsed during the connection on our demo car

Safety

Wiring is a job for a qualified installer.

MBLEM is wired into your car's 12 V electrics. We recommend fitting by a qualified installer; wrong wiring can drain your battery or damage electrical systems. Fitting isn't included in the price.

  • A suitable fused supply

    Wrong wiring can drain your battery or damage electrical systems. Ask your installer to connect the emblem to a suitable fused supply.

  • Tell your insurer

    If you fit MBLEM to a vehicle, tell your insurer about the modification.

  • A qualified installer

    We don’t publish DIY wiring steps. This page demonstrates what an installer does, not how to wire it yourself.

Questions

Before you book an installer

Still unsure? (support 24/7) or email us.

Ready when your installer is.

MBLEM 82. For BMW models with an 82 mm rear badge.

Buy Now · £199.99 Check it fits

For show, exhibition, private-land and off-road use. Not approved by MBLEM for use on public roads in Great Britain.Read product-use information

Before you check out

Confirm your MBLEM

You’re buyingMBLEM Digital Display Emblem · 82 mm
Price£199.99
DispatchOrders are dispatched within 7 days of purchase
FitsOne universal 82 mm size for the BMW models in our compatibility range. Check it fits

Your acknowledgement is recorded with your order. Your statutory rights are unaffected.

Tick the box above to continue.